Hysopt BIM Syncer can create a P&ID model (calculation model) from a Revit model. It uses a smart algorithm that first identifies the end units (heat emitters) in your system, such as radiators, fan coils, or floor heating. Then, it analyses how the system is connected with components and pipes, such as pumps, valves, or fittings. The algorithm stops when it reaches a production unit, such as a boiler, chiller, or heat pump. This way, Hysopt BIM Syncer can generate a complete and accurate P&ID model of your system.
...
Hysopt model generation settings
In settingshttps://hysopt.atlassian.net/wiki/spaces/HBF/pages/3341320351/Settings#Hysopt-model-generation section, Hysopt model generation settings allow you to customise how the generated model looks in the Hysopt software. You can change the layout of the model. These settings do not affect the performance or the results of the model, only its appearance.
Messages
Start Hysopt model generation
When you start an Hysopt model generation, the Hysopt BIM syncer will extract all BIM element relevant for calculating and validating a hydronic system out of Revit.
...
Unsuccessful Hysopt model generation
...
Unprocessed mixing/dividing point in the system. Maybe you need to mark some components as endunit on these branches
...
We found a branch with an unknown location," this might indicate that the classification type of the pipe segments is not consistent in our BIM model
This point in the system has {number} pair of branches, this is not supported yet by the generator
Errors
No end units found
...
Successful Hysopt model generation
...