General tips:
Place sensors on all places where you would like to read data from later on, e.g:
...
Boiler
...
Name circuits, add power info to all supply and end units e.g:
Usefull info for boiler:
Power [kW], Pressure loss [mbar], water capacity [l]
...
Name changes made
2.1 Energy center
There are a couple of different options where to take a control strategy for your energy center from.
Check if the same model is available in inspiration library.
If the same model is not available in inspiration library, a similar can can be made based on existing design.
Following parameters need to be accurate in the model to proceed:
Boiler capacity
Water volume
Pressure difference or pipe diameter & lengths and/or on/off valves
...
2.1.1 Distribution
If applicable, following parts can be used:
Parallel production:
...
Necessary fields:
Primary power percentage
Low Loss Header:
Necessary fields:
...
none
Points of attention:
Pump before and after LLH necessary
For low return temperature, the returning primairy flow should be kept as small as possible.
Heat exchanger:
Necessary fields:
supply and return temperatureOr
2.2 End units
Page currently under construction