The ‘Change over systems’ template consists of a basic schematic where one end-unit is used for both heating and cooling.
Change over - Basic
This template consists of a basic schematic in which an end-unit is used for both heating and cooling a building. If the temperature in the room is lower than 20°C the end-unit will be used as a heating end-unit, and if the room temperature is higher than 22°C the end-unit will be used as a cooling end-unit.
Hysopt supports the simulation of dual-mode end-units but doesn’t support the design of all the components with dual operating conditions (except for BTES and ATES systems).