...
A heat pump booster needs the same parameters as a ‘regular’ heat pump. https://hysopt.atlassian.net/wiki/spaces/HRM/pages/3089204173 Heat pump
Parameters in Base circuit
Design power
Reference evaporator temperature
Reference condenser temperature
Tables:
COP table
Power table
Activation/modulation signal
The evaporator temperature is not given as a separate input signal . (as is the case in the regular heat pump) but is propagated in simulation.
In addition, a ‘Primary design heat flow’ and a ‘Primary design regime’ need to be defined. These are quite complex and are easy to make mistakes abouton. The regime and heat flow to be filled in is the actual heat supplied to the evaporator side with the right regime to supply that heat.
...
Note that the evaporator side should always be smaller than the condenser side.
The primary design regime must be filled in such that it’s in coherence with the temperature regime further upstream the booster heat pump.
...