Hysopt BIM Syncer can create a P&ID model (calculation model) from a Revit model. It uses a smart algorithm that first identifies the end units (heat emitters) in your system, such as radiators, fan coils, or floor heating. Then, it analyses how the system is connected with components and pipes, such as pumps, valves, or fittings. The algorithm stops when it reaches a production unit, such as a boiler, chiller, or heat pump. This way, Hysopt BIM Syncer can generate a complete and accurate P&ID model of your system.
...
Unprocessed mixing/dividing point in the system. Maybe you need to mark some components as endunit on these branches
...
We found a branch with an unknown location," this might indicate that the classification type of the pipe segments is not consistent in our BIM model
This point in the system has {number} pair of branches, this is not supported yet by the generator
Errors
No end units found
...
Link & map
The Link & map button will link and map the generated Hysopt model with your Revit model.
...
Generated model contains parallel branches, this is not fully supported yet in Hysopt
...
Link & map
The Link & map button will link and map the generated Hysopt model with your Revit model.