Hysopt BIM Syncer can create a P&ID model (calculation model) from a Revit model. It uses a smart algorithm that first identifies the end units (heat emitters) in your system, such as radiators, fan coils, or floor heating. Then, it analyses how the system is connected with components and pipes, such as pumps, valves, or fittings. The algorithm stops when it reaches a production unit, such as a boiler, chiller, or heat pump. This way, Hysopt BIM Syncer can generate a complete and accurate P&ID model of your system.
...
In the Hysopt BIM Syncer we focus on heating and cooling applications while Revit piping systems are used for serveral other applications eg. domestic cold and hot water, fire protection, sanitary. Heating and cooling applications in Revit use the same piping system classification hydronic supply and hydronic return. Hysopt BIM Sycner cannot differ heating or cooling system based on piping system classifications in Revit. For this reason an assistance parameter is added to inform the Hysopt BIM Syncer if a hydronic system is a heating or cooling system. At default all hydronic systems will be generated as heating systems.
...
Unprocessed mixing/dividing point in the system. Maybe you need to mark some components as endunit on these branches
...
We found a branch with an unknown location," this might indicate that the classification type of the pipe segments is not consistent in our BIM model
This point in the system has {number} pair of branches, this is not supported yet by the generator
Errors
No end units found
...
Successful Hysopt model generation
...