Hysopt BIM Syncer can create a P&ID model (calculation model) from a Revit model. It uses a smart algorithm that first identifies the end units (heat emitters) in your system, such as radiators, fan coils, or floor heating. Then, it analyses how the system is connected with components and pipes, such as pumps, valves, or fittings. The algorithm stops when it reaches a production unit, such as a boiler, chiller, or heat pump. This way, Hysopt BIM Syncer can generate a complete and accurate P&ID model of your system.
...
When you start an Hysopt model generation, the Hysopt BIM syncer will extract all relevant BIM elements for calculating and validating a hydronic system out of Revit. If all Revit elements are extracted, processing of the Hysopt model on our Hysopt servers is done. If these actions are executed the generation of your Hysopt model is done. You will be informed by a popup message if the generation was (un)successful.
...
Unsuccessful Hysopt model generation
An unsuccessful Hysopt model generation is indicated with an orange popup message. The popup message has two buttons show details and link & map. You can close the popup message by clicking on it or it will automatically close after a set time. (see
...
Show details
Link & map
Warnings
...
Unprocessed mixing/dividing point in the system. Maybe you need to mark some components as endunit on these branches
...
We found a branch with an unknown location," this might indicate that the classification type of the pipe segments is not consistent in our BIM model
This point in the system has {number} pair of branches, this is not supported yet by the generator
Errors
No end units found
...
Successful Hysopt model generation
...