Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Mapping assistant

To start mapping, open the mapping assistant

...

Mapping

...

Icon

...

Action

...

Description

...

Enable/disable manual mapping

...

When manual mapping mode is enabled, you can map pipes, components and other elements manually. Click on an element in the Hysopt model, then click on an element in the Revit model to map. Or vice versa.

...

Highight all mapped elements

...

Show next mapping

...

Undo previous mapping

...

...

Delete all mappings

...

The mapping Assistant will guide you in :

  • creating new mappings manually

  • suggesting new mappings, based on classification and topology of components

  • walking through all mappings between the Hysopt model and the Revit model

Following 4 minute video gives a short introduction on the Mapping Assistant functionality

...

Mapping components

how to map a component?

Activate the manual mapping mode, select Select a component in Hysopt, and then select a component in Revit, or vice versa. Map them.

how to map a zone/space?

Activate the manual mapping mode, select a zonein Select a zone in Hysopt, and then select a space in Revit, or vice versa. Map them.

how to map pipes?

You can map all the pipesegments (pipes, fittings, …), but we suggest advice to just map one pipesegment in Hysopt with one pipesegment in Revit, that’s enough for the BIM feeder.

how to map a group of elements, for example a BIM object that corresponds with multiple Hysopt elements?

Just multiselect all the components in Hysopt or Revit, e.g. like in following movie :

...

Mapping suggestions

...

Icon

...

Action

...

Description

...

Show next mapping suggestion

...

Acknowledge mapping suggestion

...

Acknowledge all mapping suggestions

...

...

Show Mappings

Sync views

After enabling “Sync Views“ in the ribbon mananer, you can sync the Hysopt model view and the Revit model view. If you click on a pipe or component in one model, the mapped component will be centered and highlighted automatically in the other model.

...