...
Labels are added through the layer "Text", the label is only connected to the base circuit if it is within following radius (see picture below). When there are 2 base circuits near a label it will take the closest one.
...
Designer
Export model to PDF
When exporting your model to a PDF, a screenshot is taken of the model. Than you can chose on which papertype (A0 - A4) and which DPI (Dots Per Inch) the model must be generated.
...
Calculator (after optimize pumps and valves)
Get component list
In the component list, all the components from base circuits that are drawn inside the model are listed by type and amount.
New Wiki - Installation report
In the installation report, all the information is listed by the type of base circuit.
...
In the figure below you can see an example from a installation report.
...
Pump selection report
This report describes the most critical path for each pump individually.
In the figure below you can see an example from a pump selection report
...
Simulator
Get energy report
After a simulation you can download an energy report of your model. In this report, the energy consumption of productions and pumps can be found as well as the indication of comfort in the zones and in domestic hot water productions (satellite unit).