The exports in Hysopt are all linked to a specific part namely the designer, calculator and simulator
The following exports are available in Hysopt:
...
Before you start exporting, it divided under two buttons:
Button | Name | Explanation | Opened pop-up screen |
|---|---|---|---|
 | Export as… | Makes it possible to export the model as a JSON, PDF or DXF file. |  |
 | Create report | Makes it possible to create a component list, an installation report, a pump selection report or an energy report. |  |
It is useful to label all the necessary components before you start exporting. This will make the following part of the process significantly easier.
Labels are added through the layer "Text", the label is only connected to the base circuit if it is within the following radius (see picture below). When there are 2 base circuits near a label it will take the closest one.
...
When exporting your model to a PDF, a screenshot is taken of the model. Than In the pop-up screen, you can chose on choose which papertype paper type (A0 - A4) and which DPI (Dots Per Inch) the model must be generated.
...
Calculator (after
...
optimising pumps and valves)
Get component list
In the component list, all the components from base circuits that are drawn inside the model are listed by type and amount.
...
.
You can also choose for the component list to only include the labeled components. In this case, the list will only contain the components which have a label in their vicinity.
...
The exported excel looks like the figure below.
...
Installation report
In the installation report, all the information is listed by the type of base circuit. The pop-up screen looks like this:
...
The installation report is intended for installation and commissioning, by . By labeling all of the base circuits the exported list (Excel) excel will be linked to the scheme. So for each label, all of the calculated parameters are shown per base circuit (see example below).For Example: Circuit A shows following calculated parameters
Pump: pump head and volume flow
Three-way control valve: Kvs-value and actual authority
Balance valve on bypass: Kv-value
Balance valve for pump: Kv-value, preset and volume flow
Pipe size
In the figure below you can see an example from a an installation report.
...
Pump selection report
This report describes the most critical path for each pump individually. The pop-up screen looks like this:
...
In the figure below you can see an example from a pump selection report
...
Get energy report
After a simulation, you can download an energy report of your model. In this report, the energy consumption of productions and pumps can be found as well as the indication of comfort in the zones and in domestic hot water productions (satellite unit).